Sole-control-remotes TT8 User Manual download pdf (Page 19)

TT8

-18-

Belt and Bed - Your treadmill uses a very high-efficient low-friction bed. Performance is

maximized when the bed is kept as clean as possible. Use a soft, damp cloth or paper towel to

wipe the edge of the belt and the area between the belt edge and frame. Also reach as far as

practical directly under the belt edge. This should be done once a month to extend belt and bed

life. Use water only - no cleaners or abrasives. A mild soap and water solution along with a nylon

scrub brush will clean the top of the textured belt. Allow the belt to dry before using.

Belt Dust - This occurs during normal break-in or until the belt stabilizes. Wiping excess off with a

damp cloth will minimize buildup.

General Cleaning - Dirt, dust, and pet hair can block air inlets and accumulate on the running

belt. On a monthly basis vacuum underneath your treadmill to prevent buildup. Once a year, you

should remove the black motor hood and vacuum out dirt that may accumulate. UNPLUG

POWER CORD BEFORE THIS TASK.

BELT ADJUSTMENTS:

Tread-belt Tension Adjustment - Belt tension is not critical for most users. It is very important for

joggers and runners in order to provide a smooth, steady running surface. Adjustment must be

made from the right side of the rear roller in order to adjust tension with the 6 mm Allen wrench

provided in the parts package. The adjustment bolt is located at the end of the right side rail as

noted in diagram below.

Tighten the rear roller only enough to prevent slippage at the front roller. Turn the tread-belt

tension adjusting bolt in increments of 1/4 turn and inspect for proper tension. When an

adjustment is made to the belt tension, you must also make a tracking adjustment to

compensate for the change in belt tension. This is accomplished by turning both the tension

and tracking Allen bolts an equal amount. This adjustment should be made by turning both bolts

clockwise by no more than a 1/4 turn each time.

DO NOT OVERTIGHTEN  Over tightening will cause belt damage and premature bearing failure.

General Maintenance

Note: Adjustment is thru small hole of end cap.

Tracking

Adjustment

Side Only

Tracking

Adjustment

Side Only

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

No comments

Sole-control-remotes TT8 User Manual Page 19